New systems, honest pricing, and a crew that cleans up
HVAC replacement in celebrations, Florida done right the first time
When your system is limping through another Florida summer, HVAC replacement in celebrations, Florida is the fix that stops the repair bills. We size, supply, and install Carrier, Trane, and Rheem equipment for homes in Celebration Village, North Village, and Town Center. Same-day quotes, code-correct work, and a 1-year workmanship warranty on every install.
Live phone supportUpfront optionsBacked workmanship
What's included
What a Tech Servixo replacement includes
Every replacement quote covers the equipment, the labor, the permit, and the cleanup. Here is what shows up on the invoice and what we handle behind the scenes.
Matched equipment and coil
Condenser, air handler or furnace, and evaporator coil are AHRI-certified as a matched set. That is what makes the efficiency rating real and keeps the manufacturer warranty valid.
New refrigerant lines and condensate
We run new copper tubing and a fresh PVC condensate line rather than reusing old lines that may have held a leak. New lines get pressure tested and pulled to a deep vacuum before charging.
Permit and inspection
We pull the mechanical permit and meet the inspector on site. You get the signed-off paperwork for your records, which matters at resale.
Thermostat setup
Your existing thermostat gets rewired, or we install a new Nest or Ecobee if you want one. Staging, fan settings, and schedule are configured before we leave.
Duct leakage check
We test the duct system with a leakage tester and seal accessible leaks in the attic or closet. Sealing ducts on install day is far cheaper than a second visit later.
Haul-away and cleanup
Old equipment, packaging, and refrigerant are removed and disposed of properly. Floors and closets are protected during the work and cleaned before we leave.
Service overview
What HVAC replacement in celebrations, Florida actually involves
HVAC replacement in celebrations, Florida is the removal of your old air handler and condenser and the installation of a new matched system, including refrigerant lines, the PVC condensate line, the thermostat, and any duct work that fails a leakage test. It is not a swap-and-go job. We pull the old R-410A charge with a recovery machine, run an ACCA manual J load calculation on your home, and set the new equipment to that number so the system is not oversized.
Most calls we get in Celebration start the same way: a 12-year-old unit that cannot hold temperature past 3 p.m., a refrigerant leak we have already topped off twice, or a failed blower motor on a system the homeowner has spent $2,000 repairing. If you are searching for HVAC replacement near me celebrations Florida, the honest answer is that a new system usually costs less over five years than another round of patches. We tell you which one you are looking at.
How we workWe verify the cause, compare realistic options, and confirm the repair before we leave.
The service timeline
How our replacement process runs
The process flexes to the condition, but these checkpoints keep decisions clear.
Load calc and quote
We measure your home, check window orientation and insulation, and run an ACCA manual J load calculation. You get a written quote the same day with two or three equipment options at different price points. No pressure, no same-day-only discount games.
Equipment selection
You pick the tier. We walk through Carrier, Trane, Rheem, Goodman, and Daikin options, plus whether a heat pump makes more sense than a straight AC and furnace pair for your Celebration home. We confirm AHRI certification so the matched system qualifies for the rated efficiency.
Install day
Most replacements take one day, 6 to 9 hours. We recover the old refrigerant, pull the condenser and air handler, run new copper tubing and a fresh PVC condensate line, and set the new pad and disconnect. Floors get covered before we start.
Commissioning
We pull a deep vacuum with a vacuum pump, weigh in the charge, and verify superheat and subcooling with manifold gauges. A combustion analyzer checks the furnace side on gas systems. Then we set up your Nest or Ecobee thermostat and show you the schedule.
Walkthrough and cleanup
We test cooling at the supply registers, check static pressure, and confirm the system holds temperature. You get the manual, warranty registration, and permit paperwork. Haul-away of the old equipment is included. We leave the closet cleaner than we found it.
Tools & methods
Tools and methods we install with
Purpose-built equipment, used by trained technicians, so the job is done accurately the first time.
Manifold gauges
Used to read suction and liquid pressures and verify superheat and subcooling after charging. This is how we confirm the system is charged to the manufacturer's spec, not just 'close enough.'
Vacuum pump
Pulls the system down to a deep vacuum before charging. Moisture left in the lines is what kills compressors early, so this step is not optional.
Recovery machine
Removes the old R-410A charge from your existing system so it can be reclaimed legally under EPA Section 608 rules instead of vented.
Duct leakage tester
Measures how much conditioned air is escaping into the attic. On most Celebration homes we find 15 to 30 percent leakage on the original duct work.
Combustion analyzer
Checks flue gas on gas furnace installs for carbon monoxide and proper combustion. Required on any furnace commissioning, and a safety check we never skip.
Psychrometer and clamp meter
The psychrometer reads wet-bulb and dry-bulb to calculate real system capacity. The clamp meter reads compressor and blower amp draw against nameplate ratings.
Use cases
When Celebration homeowners replace
These examples show how the service framework adapts rather than forcing every call through one repair.
Dual-system Spring Park home
Two 12-year-old systems, one for each floor. The upstairs unit had a failed capacitor and a clogged drain line that had already stained the ceiling below the air handler closet once. → Upstairs system replaced with a matched Carrier set and a new PVC condensate line with a float switch. Downstairs system replaced the following spring. Both now on the same maintenance schedule.
Water Street District heat pump swap
An 11-year-old heat pump that would not switch to heating in January, leaving the condo at 62 degrees for three days. Reversing valve diagnosis came back as a $1,400 repair on a system near end of life. → Replaced with a Bosch heat pump sized for the unit, HOA-approved on noise rating, installed in one day. Heating and cooling both verified at the registers before we left.
Problems we solve
Problems a new system solves for good
These are the calls we run most in Celebration. Each one has a repair path and a replacement path, and we tell you which one is worth your money.
AC cannot hold temperature past mid-afternoon
We test charge, airflow, and compressor amp draw with a clamp meter. If the compressor is failing or the system is undersized, we quote a replacement sized to an ACCA manual J load calc so the new unit actually keeps up at 3 p.m.
Refrigerant leak that keeps coming back
We pressure test the line set and coil to find the leak. If it is in accessible copper we can repair it. If it is in the evaporator coil on a 12-year-old system, replacement is usually the better spend.
Clogged drain line flooding the pan
We clear the line, then install a proper trap and float switch on the new system. Replacement includes a fresh PVC condensate line routed with correct slope so it drains instead of pooling.
Failed blower motor and rising repair bills
We add up what you have spent in the last 24 months and compare it to replacement cost. If repairs are past 40 percent of a new system, we recommend replacement and show you the math.
Pricing process
What replacement costs in 2026
$6,800 - $14,500 installed, depending on tonnage, efficiency tier, and duct work
System tonnage
A 2-ton system for a small townhome costs meaningfully less than a 5-ton system for a two-story home. Tonnage comes from the manual J load calc, not from a guess based on square footage.
Efficiency tier
A 14.3-SEER2 base unit sits at the low end. A 16 to 18-SEER2 variable-speed system costs more upfront but cuts summer cooling cost 25 to 40 percent, which usually pays back within five to seven years.
Duct work condition
If the leakage test shows 25 percent loss, sealing or replacing duct runs adds cost. Doing it during the install is far cheaper than a separate duct job six months later.
How much does HVAC replacement cost in celebrations Florida?
Most full system replacements in Celebration run $6,800 to $14,500 in 2026, depending on tonnage, efficiency tier, and whether duct work needs sealing. A straight AC and furnace swap sits at the low end; a variable-speed heat pump with new flex duct and a Nest thermostat sits at the high end. We give you the exact number after the load calc, not a range over the phone.
How long does HVAC replacement take in celebrations?
A standard replacement takes one day, usually 6 to 9 hours from arrival to cleanup. If we are also replacing duct work or running new refrigerant lines through finished walls, plan on two days. We tell you which one you are getting when we quote the job, so you can plan around it.
Who installs new HVAC systems in celebrations FL?
We do. Tech Servixo installs Carrier, Trane, Lennox, Rheem, Goodman, Daikin, Mitsubishi Electric, Bosch, and American Standard equipment across Celebration and the surrounding area. Our techs are NATE certified and EPA 608 certified, and we work under a Florida state HVAC license. You get the same crew that quoted the job.
Is HVAC replacement worth it in celebrations Florida?
If your system is 12 years or older, has had two or more refrigerant leaks, or you are paying more than $150 a month in summer cooling for a 2,000 sq ft home, replacement usually wins. A new 16-SEER2 system cuts that bill 25 to 40 percent and comes with a 10-year parts warranty. We will tell you straight if a repair still makes sense.
Related services
Related Services
furnace repair
If your furnace is short-cycling or the igniter will not light, we diagnose it before you commit to replacement. Sometimes a $180 repair buys you two more winters in Celebration. Sometimes it does not, and we say so.
air conditioning repair
AC not cooling, frozen evaporator coil, or a bad capacitor are the three calls we run most in Celebration. We fix what is fixable and tell you when a repair is throwing money at a dying system.
furnace replacement
When the heat exchanger is cracked or the furnace is past 15 years, we replace it and pair it with a matched coil and condenser. AHRI-certified pairing keeps your efficiency rating honest.Ready when you are
Get your HVAC replacement in celebrations, Florida quoted today
One call gets you a load calc, a written quote, and a straight answer about whether you need a new system or a repair. Licensed, insured, and warrantied. Call (844) 796-4282 and we will get you on the schedule.
Talk with the local team
Request HVAC replacement
Call (844) 796-4282 any time, day or night. Our phones are answered around the clock, and same-day appointments are usually available if you reach us before noon. You can also email [email protected] or stop by our office in Celebration. We will confirm your appointment window and give you a call when the tech is on the way.